Rescue 1060 Manuel du propriétaire télécharger pdf (Page 6)

Get Started

Components

Charge the Rescue Portable Power Pack before use. It is best to

charge the Portable Power Pack until the full charge light on the

control panel turns on.

Please read all instructions before use.

To ensure maximum battery life, charge at least every 30 days, and

after each use. Extreme ﬂuctuations of either hot or cold outside

temperatures may require re-charging more often.

REVERSE POLARITY

All models feature an Audible Safety Alarm. When the unit is OFF

and you hook-up your clamps, you will hear a loud, steady beep (this

indicates a polarity problem), disconnect the Portable Power Pack

clamps from the battery. Check to insure the red clamp is connected

to the battery terminal and the clamp is connected to ground on the

vehicle.

A green light indicates the unit is turned on.

1 Positive (+) Jumper Cable

2 Negative (

) Jumper Cable

3 Clamp Lights ON/OFF Switch (Models 950, 1060 and 3000)

4 Power ON/OFF Switch

5 Charge Status Indicator Lights

6 Battery Level Test Button

7 Full Charge Light

8 Reverse Connection Warning LED Light (Flashing Red)

9 Charging Light

10 12 Volt DC Power Outlet

11 120 Volt AC Charging Port (back of unit)

12 AC Cord

13 Worklight Safety Switch (3 Position: ON, Flashing, OFF)

14 Battery Status Meter

15 Audible Signal and Light

16 Clamp Lights (Models 950, 1060 and 3000)

17 On Status Light (Steady Green)

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Rescue 1060 Manuel du propriétaire Page 6