Rescue 1060 Manuel du propriétaire télécharger pdf (Page 3)

10 12 Volt DC Power Outlet

11 120 Volt AC Charging Port

(back of unit)

12 AC Cord

13 Worklight Safety Switch (3 Position:

ON, Flashing, OFF)

14 Battery Status Meter

15 Audible Signal and Light

16 Clamp Lights (Models 950, 1060

and 3000)

17 On Status Light (Steady Green)

18 950 has a compressor, 1060 has

a compressor and inverter

1 Positive (+) Jumper Cable

2 Negative (

) Jumper Cable

3 Clamp Lights ON/OFF Switch

(Models 950, 1060 and 3000)

4 Power ON/OFF Switch

5 Charge Status Indicator Lights

6 Battery Level Test Button

7 Full Charge Light

8 Reverse Connection Warning

LED Light (Flashing Red)

9 Charging Light

• Failure to keep internal battery charged will lead to permanent battery damage.

• Connecting a discharged battery to charged system could cause overheating or explosion.

WARNING – Risk of Battery Explosion, Fire or Failure

Before using your portable power pack, you should fully charge it. The fully

charged indicator light will come on when the unit has been charged. Recharge

every 30 days or when the gauge indicates less than full charge. Fluctuations

in temperature can accelerate battery discharge. Check your unit often.

Using your Rescue

Power Pack to Jump

Start Vehicles or Equipment

• Make sure the power switch is OFF.

• Connect the red (positive +) clamp to the positive terminal or post on the

discharged battery.

• Connect the black (negative –) clamp to a ground away from the battery,

such as an alternator bracket.

• Turn the power switch ON.

• Start the engine.

• Turn the power switch OFF.

• Disconnect the clamps, ﬁrst negative and then positive.

To jump start a vehicle or machine:

1 2 3 4 5 6 7 8 ... 15 16

Commentaires sur ces manuels

Pas de commentaire

Rescue 1060 Manuel du propriétaire Page 3

Commentaires sur ces manuels

Produits connexes et manuels pour Unités d'alimentation électrique Rescue 1060